Chevrolet
Third door handle breaks
Inside door handle rattles
Hood Hinge Rattle
Window binds/glass tips forward when opening
Rear Roof Perforation
Recall: Air bag sensing diagnostic module contains anomaly
General water leak diagnosis guide
Roof perforation (replace roof)2002 and earlier GM Passenger cars, trucks
Chemical damage to the polycarbonate headlamp lenses
According to bulletin No. 02-08-001, shops and customers should be aware of chemical damage to exterior polycarbonate headlamp lenses, found on most late-model vehicles. This material is used for its resistance to high impacts and temperatures. The material is also sensitive to a variety of chemicals, causing cracking or “crazing.” The lenses should be protected from chemicals, especially those used for rail dust removal, rubbing compounds and cleaners. back1996-2002 Chevrolet and GMC S/T Extended Cab S-10s and SonomasThird door handle breaksOwners of some 1996-2002 Chevrolet and GMC S/T Extended Cab S-10s and Sonomas may report that the third door is hard to open and that the handle may be broken. Follow these steps to adjust the lock rods:
Remove the door trim.Release both the lock rods from the lock rod retainer.Position the upper lock rod first (see fig. 1). Postion the lock rod in the retainer so that there is a 10 mm to 12 mm, or about 11 to 12 threads showing, from the end of the rod.Important: Make sure the upper striker is not bound against the latch. If this were to occur, push the door inboard to release the latch. To correct a bound latch, adjust the striker until it is centered with the latch.Position the lower lock rod in the retainer where it rests, usually 5 mm to 6 mm of thread from the end of the rod after the upper lock rod is locked in place.Install the door trimback1998-2002 Chevrolet Camaro
Inside door handle rattles
A rattle or buzz from the inside of the door handle may be caused by the door look lever rubbing or vibrating against the inside door handle bezel. To repair the handle, follow these steps:Remove the inside door handle bezel.Apply a 10 mm x 30 mm (3/8-in. x 1 3