Dent Fix Equipment releases new Parking Sensor & Lens Hole Maker

    Feb. 16, 2018
    The Parking Sensor and Lens Hole Maker (Part No. DF-EZ10) from Dent Fix Equipment is the precise and clean way to create holes in order to install driver assist sensors on replacement bumpers.
    The Parking Sensor and Lens Hole Maker (Part No. DF-EZ10) from Dent Fix Equipment is the precise and clean way to create holes in order to install driver assist sensors on replacement bumpers. The DF-EZ10 system is designed to punch a hole in the bumper or fender without damaging the paint.

    Ease of use combined with a wide variety of sizes, makes this tool a must have for any shop. Able to cut holes in plastic bumpers up to 5mm in thickness, the kit includes a 5/16" HSS drill bit to create a guide hole and varied discs that can punch holes in the following sizes (mm):17, 18, 18.2, 19, 20, 22.5, 24, 26, 26.7, & 32. Contact your local Dent Fix Distributor today.

    About the Author

    ABRN Wire Reports

    These are press releases approved by our ABRN Editors

    Continue Reading

    Sponsored Recommendations

    Enhance your collision repair workflow with Autel’s IA900, a process-driven solution integrating precision alignment, bi-directional diagnostics, and ADAS calibration. Designed...
    The Autel IA700 is a state-of-the-art and versatile wheel alignment pre-check and ADAS calibration system engineered for both in-shop and mobile applications...
    Originally published by Modern Tire Dealer on Sep 4, 2024 | Written by Mike MangesTire dealers who aren't offering advanced driver assistance system (ADAS)
    In this edition of Ask the Expert, Autel’s Stewart Peregrine and Eric Sponhaltz share valuable insights to help shops prepare for ADAS service, ensuring compliance, profitability...